WXB-H01
Posted: Thu Apr 23, 2020 11:43 amI just finished fitting the glare shield after dropping the bottom skin and crawling up inside to drill and cleco everything. It looks like I better hang the gas tank before I go any further. I don't see any mention of it on F06 or F07 where I'm doing the glare shield but G01 doesn't give any sequence of events either, just measurements etc. My question is this the right time to hang it and is it safe to rivet the glare shield now or should I leave all the cleco's in place for now. I still have the seat mostly in cleco's and have found it necessary to pull it out twice and probably will have it out again when I install the controls and autopilot.