Page 1 of 1
WIX-F10-24 Waiex attach plates
Posted:
Sun Jan 03, 2021 6:31 pmby wingnut99
Anybody know where these attach plates go?
The parts box is pretty empty and I haven't run across them on the plans yet. Looked over the plans several times and have not seen them. Also I have 2 hat sections that I haven't seen on the plans either. Look like a cover for pushrods maybe?
Thanks
Re: WIX-F10-24 Waiex attach plates
Posted:
Wed Jan 06, 2021 11:52 pmby Sonex1517
I wanted to bump this up. Didn’t see a reply.
Re: WIX-F10-24 Waiex attach plates
Posted:
Thu Jan 07, 2021 10:31 amby scotttro
Up at the top of F10, just left of the "The information disclosed herein" box; they go on either side of the cap assembly. They're visible in F09 too, by the reference arrows for C-C.
Re: WIX-F10-24 Waiex attach plates
Posted:
Sat Jan 09, 2021 7:07 amby epeachey
I had the same left over parts so I sent a picture and request for help to sonex support. Reply copied below.
Those parts are packing list errors, carried over from the Legacy Waiex packing lost. The XNS-Z04-01 Hat Section covered an exposed elevator pushrod in the middle of the seat and the gussets are part number WIX-F10-24, also used in the installation of the Legacy Waiex seat.
Thank you for bringing these to our attention. I will make sure they are removed from the packing list.
Blue Skies…..
Kerry
Sonex Aircraft Tech Support